Cisco Firepower 2130 Installation & Maintenance page 16

Hide thumbs Also See for Firepower 2130:

Secure the Power Cord on the Power Supply Module

One side of the tie wrap has evenly spaced ridges and the other is smooth. Be sure the ridged side is face up and that you

slide it through the open side of the channel. You will hear a click as the tie slides through—it moves in one direction

only. To remove the tie wrap from the clamp, push the lever on the closed side of the box-shaped channel and slide out

the tie wrap.

Figure 7: Tie Wrap Through the Box Channel of the Clamp

Box channel

Step 2

Attach the clamp to the power supply module:

a) Locate the hexagonal ventilation hole on the power supply module at the center of the plug just below the power

connector body (see the following figures).

b) Plug the snapping portion of the tie wrap into the hexagonal hole.

c) With the clamp side facing up, push the tie wrap in until it is fully engaged.

Caution

Installation, Maintenance, and Upgrade

Make sure you have the correct location because you cannot remove the tie wrap from the power supply

module once you have installed it without damaging the tie wrap.

Installation, Maintenance, and Upgrade

Tie wrap

Table of Contents

Firepower 2140