Table of Contents
Advertisement
Power connector port
Removing the DC-in Connector
Steps
1. Follow the procedures in
2. Remove the:
a.
base cover
b.
battery
3. Perform the following steps to remove the I/O board:
a. Disconnect the DC-in cable from the connector to the system board [1].
b. Remove the M2x3 screw that secures the DC-in connector to the computer [2].
c. Lift the DC-in connector from the computer [3].
Installing the DC-in Adapter Port
Steps
1. Place the DC-in adapter port into the slot on the palm-rest assembly.
2. Route the power-adapter port cable through its routing guides on the palm-rest assembly.
3. Replace the M2x3 screw that secures the power-adapter port to the palm-rest assembly.
4. Connect the power-adapter port cable to the system board.
5. Install the:
a.
Battery
b.
Base cover
6. Follow the procedures in
System board
Removing the System Board
Steps
1. Follow the procedures in
Before Working Inside Your
After Working Inside Your
Before Working Inside Your
Computer.
Computer.
Computer.
Disassembly and reassembly
31
Advertisement
Table of Contents
