Replacing The Embroidery Foot - Brother 888-L91 Operation Manual
Hide thumbs
Also See for 888-L91:
- Technical reference booklet (24 pages) ,
- Quick reference manual (20 pages) ,
- Operation manual (101 pages)
Table of Contents
Advertisement
■ Canceling the operation beep
a
Press
to display the settings screen.
b
Display page 4.
c
Set "Buzzer" to "OFF."
Replacing the embroidery foot
CAUTION
• Only use embroidery feet designed specifically
for this machine. Use of any other embroidery
foot may result in injuries or damage to the
machine.
a
Press
(Needle position button) once or twice to
raise the needle.
b
Press
.
→ The screen changes, and all keys and operation
buttons are locked (except
c
Raise the presser foot lever.
d
Use the included screwdriver to loosen the embroidery
foot screw, and then remove the embroidery foot.
a
c
1 Screwdriver
2 Embroidery foot
3 Embroidery foot screw
e
f
).
g
b
h
i
j
Hold the embroidery foot with your right hand, as
shown.
Hold the embroidery foot with your index finger
wrapped around the lever at the back of the foot.
a
1 Lever
2 Embroidery foot bar
While pressing in the lever with your finger fit the
embroidery foot bar over the needle clamp screw and
then fit the presser foot holder screw into the presser
foot mounting notch to attach the embroidery foot to
the presser foot bar.
c
1 Embroidery foot bar
2 Needle clamp screw
3 Mounting notch
Secure the embroidery foot with the presser foot
holder screw.
Set the embroidery foot perpendicular.
a
1 Presser foot holder screw
Slowly lower the presser foot lever.
Raise the presser foot lever to check that the
embroidery foot is securely attached.
Press
to unlock all keys and buttons.
Care and Maintenance
b
a
b
Appendix A-5
A
Advertisement
Table of Contents
Troubleshooting
