Table of Contents
Advertisement
Adjusting the Discharge-Chute
Latch
If the discharge chute does not lock into the desired position
or does not unlock so that you can move it to another
position, adjust the discharge-chute latch.
1. Remove the fastener on the gear cover
the front of the cover up, and slide it back and out of
the way.
2. Loosen the bolt on the cable clamp
1. Cable conduit
3. Grasp the cable conduit and move it toward the front
of the machine until the discharge-chute latch fully
engages the gear teeth
1. Discharge-chute latch
(Figure
Figure 55
(Figure
56).
Figure 56
2. Cable clamp
(Figure 56
and
Figure
Figure 57
2. Gear teeth
Note: The latch is spring loaded and naturally moves
into the teeth of the gear
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp, being careful not
to strip the plastic part.
55), lift
6. Install and secure the gear cover.
Replacing the Drive Belts
If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, have an
Authorized Service Dealer replace the belt.
Replacing the Headlight Bulb
Use a GE 899 37W halogen light bulb. Do not touch the
bulb with your hands or allow dirt or moisture to come into
contact with the bulb.
1. Remove the wire connector from the back of the
headlight
2. Turn the base of the bulb counterclockwise until it
stops
57).
3. Remove the bulb straight out from the back of the
headlight
23
(Figure
(Figure
58).
Figure 58
(Figure
59).
Figure 59
(Figure
60).
57).
Advertisement
Table of Contents
