Advertisement
3-7
RH
(Arm type, moving arm type, gantry type 4th-axis option/
XZ type 3rd-axis option)
!
CAUTION
When fixing with the tap holes, always fix at several holes. If fixed with only one
hole, the loosening torque could act during operation can cause loosening.
If the rotary axis RH is attached to the 4th-axis, install the tool onto the shaft at
the end of RH.
Five M8 coarse thread tap holes are opened on the end of the shaft. Install the tool
using these holes. The tool can also be installed with a bolt coupling or split
clamp using the outer diameter of the shaft.
NOTE
The φ75 section shown below is the non-movable section. The rotary shaft is the
section below φ38.
φ35h7
φ75h8
Fig. 10-16 RH
10-17
Get other manuals https://www.bkmanuals.com
φ38
φ98
0
-0.2
5-M8×1.25
Depth20
(PCD. 20)
Chapter 10 HXYX
Advertisement
Chapters
