Advertisement
Chapter 9 MXYX
3-5
ZFH
(Arm type, gantry type, moving arm type 3rd-axis option)
XZ 2nd-axis option
When using the 3rd-axis model with ZFH for the 3rd-axis, install the workpiece
onto the ZFH frame in the following manner.
Four M5 coarse thread tap holes and a φ5 reamer hole are opened on the frame's
workpiece installation surface. Install the tool using these holes. The tap depth is
9mm.
There is a step on the ZFH frame.
The actual tool installation surface is the shaded section shown above.
!
If the fitting length is less than 9mm, the threads could be damaged during
tightening. If the screw length exceeds 27mm from the installation surface, the
screw could contact the bottom.
A
Fig. 9-13 Tool installation ZFH
NOTE
CAUTION
Get other manuals https://www.bkmanuals.com
70
(Tolerance between knock (0.02)
31
28
31
SEC A-A
9-12
4-M5×0.8 Depth9
φ
2-
5H7 Depth8
A
Advertisement
Chapters
