Operation - Craftsman PRO Series Operator's Manual
Electric start snow thrower
Hide thumbs
Also See for PRO Series:
- Operator's manual (64 pages) ,
- Manual (60 pages) ,
- Operator's manual (60 pages)
Table of Contents
Advertisement
Available languages
Available languages
Speed Selector Lever
Fuel Tank
Chute Assembly
Drift Cutter
Auger
Snow thrower controls and features are described below and illustrated in Figure 15.
Speed Selector Shift Lever
The speed selector shift lever is located on the right side of the
handle panel. Place the speed selector shift lever into any of eight
positions to control the direction of travel and ground speed.
Forward
Your snow thrower has six forward (F) speeds. Position one (1) is
the slowest and position six (6) is the fastest.
Reverse
Your snow thrower has two reverse (R) speeds. Position one (1) is
the slower and position two (2) is the faster.
Craftsman Snow Throwers conform to the safety standard of the American National Standards Institute (ANSI)
OPERATION
Headlight
Meets ANSI Safety Standards
Wheel Drive Control
Heated Grip Switch
Two Way Chute Pitch Control™
Auger Control
Heated Grip
Wheel Steering Control
Primer
Clean-Out Tool
Safety
Key
Choke
Control
Auger Housing
Skid Shoe
Figure 15
Choke Control
The choke control is found on the rear of the engine and is
activated by rotating the knob counter-clockwise. Activating
the choke control closes the choke plate on the carburetor
and aids in starting the engine.
Safety Key
The safety key is a safety device. It must be fully inserted in
order for the engine to start. Remove the safety key when
the snow thrower is not in use.
NOTE: Do not turn the safety key in an attempt to start the
engine. Doing so may cause it to break.
13
Chute Directional Control
Recoil Starter
Oil Fill
Handle
Throttle
Control
Electric Starter Outlet/
Oil Drain
Switchbox
Fuel Cap
Electric
Starter
Button
- Quick Links:
- Service and Maintenance
Hide quick links:
Advertisement
Chapters
Table of Contents
