Download Print this page

Install Rail Brackets Using The Adapter Hardware (For Threaded Hole Racks); Attach Bracket To Front Of Rack - Dell EMC Data Domain DD9800 Installation Manual

Installation and storage expansion guide

Hide thumbs Also See for EMC Data Domain DD9800:

Table of Contents

Figure 10. Attach bracket to front of rack

6. Verify that the bracket is level.

7. Repeat the steps to attach the remaining bracket to the other side of the rack.

8. After installing both brackets, make sure that they are level with one another.

Install rail brackets using the adapter hardware (for threaded hole

racks)

About this task

NOTE:

● If you are using a rack with square or round holes, go to

round hole racks)

● Only use this procedure if your rack has tapped holes that are M5, M6, 10/32, or 12/24.

● The adapter hardware is shipped in the rack mount kit.

● You will need a long handled screwdriver with a shank diameter less than 7.0 mm and the wrench (included in the kit) to

tighten the nuts.

Steps

1. Locate the two adapters from the rail kit.

on page 15 section.

Install rail brackets on the Data Domain racks (for square or

Install the System in the Rack

Table of Contents