Samsung HW-S800B, HW-S801B - Wireless Dolby Atmos Soundbars Manual

CHECKING THE COMPONENTS

Soundbar Main Unit / Soundbar Remote Control / Subwoofer / Power Cord X 2 (Subwoofer, Soundbar) / AC/DC Adapter / HDMI to Micro HDMI Cable / Wall Mount
Guide / Holder-Screw X 2 / Screw (M5 X L55) X 4 / Screw Anchor X 4 / Bracket-Wall Mount X 2

NOTE

• For more information about the power supply and power consumption, refer to the label attached to the product. (Label: Bottom of the Soundbar Main Unit)
• To purchase additional components or optional cables, contact a Samsung Service Centre or Samsung Customer Care.

PRODUCT OVERVIEW

Top Panel of the Soundbar

	(Multi Function) Button In standby mode, press the (Multi Function) button to turn on the Soundbar. Press the (Multi Function) button to change the mode.
	(Mic On/Off) Button Press the button to turn the microphone on or off. When the microphone is off, the LED indicator will light red.
	LED indicator The LED Indicator flashes, glows, or changes colour depending on the Soundbar's current mode or status.

Rear Panel of the Soundbar

	SERVICE Connect a USB storage device to upgrade the product's software.
	HDMI (ARC) Connect to the HDMI jack on a TV.
	DC 19V Connect the AC/DC power adapter. (Power Supply In)

CONNECTING THE SOUNDBAR

Connecting the power and units

• The LINK LED indicator stops blinking and glows a solid blue when a connection is established between the Soundbar and the Wireless Subwoofer.

USING A WIRED CONNECTION

HDMI to Micro HDMI Cable

Connecting using an HDMI to Micro HDMI Cable

NOTE

• When using an HDMI to Micro HDMI cable, take caution not to break the cable terminal.
• When the TV sound is not output, press the (Multi Function) button at the top of the Soundbar or the (Source) button on the remote control to select the "TV ARC" mode.
• The recommended cable is High Speed HDMI Cable with Ethernet.

Using the Q-Symphony Function

For Q-Symphony, the Soundbar syncs with a Samsung TV to output sound through two devices for optimum surround effect. When the Soundbar is connected, the menu, "TV+Soundbar" appears under the Sound Output menu of the TV. (The message above differs with the TV model.)

• TV menu example: TV + [AV] Soundbar series name (HDMI/Wi-Fi)

NOTE

• It can operate according to the Codec supported by TV.
• This function is supported only when the HDMI Cable or Wi-Fi is connected.
• The message displayed may differ with the TV model.
• Ensure that your TV and Soundbar are connected to the same wireless router/frequency.
• This function is available in some Samsung TVs and some Soundbar models.

Using the Spacefit Sound

Provides optimized sound quality by analyzing the listening spaces.

USING A WIRELESS CONNECTION

Connecting via Bluetooth

NOTE

• If asked for a PIN code when connecting a Bluetooth device, enter <0000>.

Connecting via Wi-Fi (Wireless Network)

• To connect a Soundbar to a mobile device via a wireless network (Wi-Fi), the SmartThings app is required.
  1. Connect your mobile device (smartphone, tablet, etc.) to the Wi-Fi network the TV is connected to.
  2. Install and launch the SmartThings app on your mobile device (smartphone, tablet, etc.).
  3. Follow the instructions in the app screen on the mobile device to connect the Soundbar to your Wi-Fi network.

TROUBLESHOOTING

Before seeking assistance, check the following.

Soundbar does not turn on.

• Check whether the power cord of the Soundbar is correctly inserted into the outlet.

If the subwoofer does not connect automatically

1. Turn off the Soundbar main.
2. Press and hold ID SET on the rear of the subwoofer for at least 5 seconds.
   
3. Press the Up button on the remote control for 5 seconds.
   
   
4. Check if the LINK LED is solid blue (connection complete).
   • The LINK LED indicator stops blinking and glows a solid blue when a connection is established between the Soundbar and the Wireless Subwoofer.

Soundbar works erratically.

• After removing the power cord, insert it again.
• Try again after initialising the product.
• If there is no signal, the Soundbar automatically turns off after a certain period of time. Turn on the power.

If the remote control does not work.

• Point the remote directly at the soundbar.
• Recharge the remote control.

The Soundbar indicator turns solid red.

• The microphone is turned off.
  Turn on the microphone.
  

Sound is not output from the soundbar.

• The volume of the Soundbar is too low or muted. Adjust the volume.
• When any external device (STB, Bluetooth device, mobile device, etc.) is connected, adjust the volume of the external device.
• For sound output of the TV, select Soundbar.
  (Samsung TV: Home ( ) → Menu → Settings ( ) → All Settings ( ) → Sound → Sound Output → Select Soundbar)
• Remove the cable from the Soundbar and then reconnect it.

Sound is not output from the subwoofer.

• Check whether the LED on the rear of the Subwoofer lights in blue. Reconnect it when the blue LED blinks or the red LED lights.

If the TV is not connected via HDMI (ARC)

• Check whether the HDMI cable is correctly connected to the ARC terminal.
• Connection may not be possible due to the connected external device (set-top box, game console, etc.). Directly connect the Soundbar.
• HDMI-CEC may not be activated on the TV. Turn on the CEC on the TV menu.
  (Samsung TV: Home ( ) → Menu → Settings ( ) → All Settings ( ) → Connection → External Device Manager → Anynet+ (HDMI-CEC) ON)

Soundbar will not connect via Bluetooth.

• When connecting a new device, switch to "BT PAIRING" for connection. (Press the PAIR button on the remote control or press the (Mic On/Off) button on the body for at least 5 seconds.)
• Reconnect it after removing the Bluetooth speaker list on the device to connect. (Samsung TV: Home ( ) → Menu → Settings ( ) → All Settings ( ) → Sound → Sound Output → Bluetooth Speaker List)

Sound drops out when connected via Bluetooth.

• Some devices can cause radio interference if they are located too close to the Soundbar. e. g. microwaves, wireless routers, etc.
• If your device that is connected via Bluetooth moves too far away from the soundbar, it may cause the sound to drop out. Move the device closer to the soundbar.
• If a part of your body is in contact with the Bluetooth transceiver or the product is installed on metal furniture, the sound may drop out. Check the installation environment and conditions for use.

Soundbar will not connect to Wi-Fi.

• Make sure the wireless router is turned on and then reconnect the wireless router after rebooting.
• The soundbar will not connect if the wireless signal is too weak. Try moving the router closer to the soundbar, or eliminating any obstacles that are between the soundbar and the router, if possible.

The soundbar does not turn on automatically with the TV.

• When you turn off the Soundbar while watching TV, power synchronization with the TV is disabled. First turn off the TV.

LICENCE

Dolby, Dolby Atmos, and the double-D symbol are registered trademarks of Dolby Laboratories Licensing Corporation.
Manufactured under license from Dolby Laboratories.
Confidential unpublished works.
Copyright © 2012-2021 Dolby Laboratories. All rights reserved.

For DTS patents, see http://patents.dts.com. Manufactured under license from DTS, Inc. (for companies headquartered in the U.S./Japan/ Taiwan) or under license from DTS Licensing Limited (for all other companies). DTS, Digital Surround, Virtual: X, and the DTS logo are registered trademarks or trademarks of DTS, Inc. in the United States and other countries. © 2021 DTS, Inc. ALL RIGHTS RESERVED.

The terms HDMI, HDMI High-Definition Multimedia Interface, HDMI Trade dress and the HDMI Logos are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

• Use your phone, tablet or computer as a remote control for Spotify. Go to spotify.com/connect to learn how
• The Spotify Software is subject to third party licenses found here: https://www.spotify.com/connect/third-partylicenses.

• Apple, Airplay, iPhone, iPad, and Mac are trademarks of Apple Inc., registered in the U.S. and other countries.
• Use of the Works with Apple badge means that an accessory has been designed to work specifically with the technology identified in the badge and has been certified by the developer to meet Apple performance standards.

[ENERGY STAR]

ENERGY STAR qualified model only

• Your Samsung product is ENERGY STAR qualified in its factory default setting. Change to certain features, settings and functionality in this product can change the power consumption, possibly beyond the limits required for ENERGY STAR qualification.
• Environmental Protection Agency and Department of Energy. ENERGY STAR is a joint program of the Government agencies, designed to promote energy efficient products and practices.

Refer to www.energystar.gov for more information of the ENERGY STAR Program.

ENERGY STAR qualified model only
(Applicable to Thin Client models only)

As an ENERGY STAR® Partner, SAMSUNG has determined that this product meets the ENERGY STAR® guidelines for energy efficiency.

• The ENERGY STAR Program has been to reduced greenhouse gas emissions and save energy through voluntary labeling.
• Power management setting of this product have been enabled by default, and have various timing setting from 1 minutes to 5 hours.
• The product can wake with a button press on the chassis from sleep mode.

ENERGY STAR qualified model only (The other models)

• As an ENERGY STAR Partner, Samsung has determined that this product or product models meets the ENERGY STAR guideline for energy efficiency.

To send inquiries and requests for questions regarding open sources, contact Samsung Open Source (http://opensource.samsung.com)

IMPORTANT NOTES ABOUT SERVICE

Figures and illustrations in this User Manual are provided for reference only and may differ from actual product appearance.

SPECIFICATIONS AND GUIDE

NOTE

• Samsung Electronics Co., Ltd reserves the right to change the specifications without notice.
• Weight and dimensions are approximate.

Precaution: The Soundbar will restart automatically if you turn on/turn off Wi-Fi.

To deactivate Wi-Fi connection:
Press and hold the CH LEVEL button on the remote control of the Soundbar for more than 30 seconds to turn on or off the Wi-Fi connection.

To deactivate Bluetooth connection:
Press and hold the TONE CONTROL button on the remote control of the Soundbar for more than 30 seconds to turn on or off the Bluetooth connection.

Videos

Samsung S800B Soundbar 2022 Unboxing, Setup, Dimensions and Tests on TV, Music and Movies Video

Documents / Resources

References

• Patents - DTS
• ENERGY STAR | The simple choice for energy efficiency.
• Samsung Open Source

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Samsung HW-S800B, HW-S801B - Wireless Dolby Atmos Soundbars Manual