Table of Contents
Advertisement
4 After use information and maintenance
4.1 Repair
Only the manufacturer or a person appointed by the manufacturer is allowed to carry out repairs.
Components with mechanical damages (e.g. resulting from a fall) must be replaced!
Only use original spare parts or the ones approved by the manufacturer while carrying out repairs.
For further information on the availability and suitability of spare parts, please refer to our Söll XENON
Information Guide or contact your installer or alternatively, contact the customer service person re-
sponsible for your area. (see section „5.2 Contact").
4.2 Inspection
once every 12 months. Critical environmental conditions (dirt, dust, chemical impacts, temperature,
Always ensure manufacturer's instructions and statutory regulations are taken into account when
inspecting the Söll XENON anchor device.
Note:
If the device has not been used for a period longer than 1 year, ask an expert to inspect
device before reusing it!
Danger!
A defective anchor device or the one subjected to stresses resulting from a fall should no
longer be used and removed from service. It may only be used again if an expert appro-
ves such use in writing.
Note:
An expert is:
„a person who has adequate knowledge in the area of personal safety equipment for pro-
and successful completion of a training program provided by Miller) and experience and
who is knowledgeable about the applicable safety regulations, accident prevention re-
or other contracting countries of the agreement across the European economic zone) to
such an extent that he can assess the safe working condition and proper use of personal
safety equipment for protection against falling."
Warning:
An expert is not authorized to carry out repairs.
Before and during each use of the anchor device, ensure attention is paid to the correct functioning of
all components.
www.fall-protection.com
13
Advertisement
Table of Contents
