Table of Contents
Advertisement
9.
Rotate the secondary sliding sheave
clockwise and push it so that it separates
from the secondary fixed sheave.
1. Secondary sliding sheave
2. Secondary fixed sheave
10. Install the V-belt between the secondary
sliding and fixed sheaves.
1. V-belt
11. Install the drive guard, and then install the
left side cover and the shroud.
ESU12100
Drive chain housing
EWS00430
WARNING
The engine, oil tank, brake disc, and cool-
ant hoses will be very hot after the engine
has been run. Avoid contact while they are
still hot with any part of your body or cloth-
ing during inspection or repair.
To check the drive chain housing oil level
1.
Place the snowmobile on a level surface.
Periodic maintenance
2.
Remove the shroud and the right side
cover. (See page 40 for removal proce-
dures.)
3.
Remove the dipstick, wipe it off with a
clean rag, and then insert it back into the
filler hole.
1. Dipstick
4.
Remove the dipstick and check that the
oil is between the maximum and mini-
mum level marks. If the oil is below the
minimum level mark, add sufficient oil of
the recommended type to raise it to the
maximum level mark.
1. Maximum level mark
2. Minimum level mark
55
Advertisement
Table of Contents
