Activating and deactivating the no-wake
mode
The activation of the no-wake mode can be
confirmed by the no-wake mode indicator on
the multifunction information center.
No Wake +1
0
13.6V
1 No-wake mode indicator
2 No-wake mode level
To activate the no-wake mode:
(1) Shift into neutral, or release the throttle
lever and let the engine speed return to
idle.
(2) Push and hold the "NO-WAKE MODE"
switch. Once the beeper sounds three
times and the no-wake mode indicator is
displayed, the no-wake mode is activat-
ed.
1
1 "NO-WAKE MODE" switch
2 "SPEED CONTROL" up switch
3 "SPEED CONTROL" down switch
(3) Push the "SPEED CONTROL" up switch
or "SPEED CONTROL" down switch to
adjust the engine speed to three set-
MPH
x100
RPM
1
2
2
3
Watercraft operation
tings: "No Wake –1", "No Wake" (stan-
dard setting), and "No Wake +1".
To deactivate the no-wake mode:
Perform one of the following operations. The
beeper sounds two times and the no-wake
mode indicator disappears when the no-
wake mode is deactivated.
Push the "NO-WAKE MODE" switch.
Squeeze the throttle lever.
Squeeze the RiDE lever.
TIP:
100
%
The no-wake mode is also deactivated when
F
the engine is stopped.
EJU45031
Drive control mode
The drive control mode is a function for set-
ting the maximum watercraft speed and ac-
celeration for stable towing and to support
inexperienced operators.
The maximum watercraft speed can be se-
lected from three settings and the accelera-
tion can be selected from two settings.
TIP:
The watercraft speed setting is a target value.
The actual watercraft speed may vary de-
pending on the operating conditions.
Activating the drive control mode
Activation of the drive control mode can be
confirmed by the drive control mode indica-
tor on the multifunction information center.
When the drive control mode is activated, the
drive control mode indicator is shown in light
blue.
1 Drive control mode indicator
To activate the drive control mode:
(1) Release the throttle lever and let the en-
gine speed return to idle.
1
35