Connecting Devices To The Ethernet Ports; 10/100/1000/Multigigabit Ethernet Port Connections; Auto-Mdix Connections; Poe And Poe+ Port Connections - Cisco Catalyst 9200 Series Hardware Installation Manual
Hide thumbs
Also See for Catalyst 9200 Series:
- Configuration manual (276 pages) ,
- Installing manual (8 pages) ,
- Instructions (4 pages)
Table of Contents
Advertisement
Connecting Devices to the Ethernet Ports
Connecting Devices to the Ethernet Ports
10/100/1000/Multigigabit Ethernet Port Connections
The switch 10/100/1000 and Multigigabit Ethernet port configuration changes to operate at the speed of the
attached device. If the attached ports do not support autonegotiation, you can manually set the speed and
duplex parameters. Connecting devices that do not autonegotiate or that have the speed and duplex parameters
manually set can reduce performance or result in no linkage.
To maximize performance, choose one of these methods for configuring the Ethernet ports:
• Let the ports autonegotiate both speed and duplex.
• Set the interface speed and duplex parameters on both ends of the connection.
Auto-MDIX Connections
The autonegotiation and the auto-MDIX features are enabled by default on the switch.
With autonegotiation, the switch port configurations change to operate at the speed of the attached device. If
the attached device does not support autonegotiation, you can manually set the switch interface speed and
duplex parameters.
With auto-MDIX, the switch detects the required cable type for copper Ethernet connections and configures
the interface accordingly.
If auto-MDIX is disabled, use the guidelines in this table to select the correct cable.
Table 12: Recommended Ethernet Cables (When Auto-MDIX is Disabled)
Device
Switch to switch
Switch to hub
Switch to computer or server
Switch to router
Switch to IP phone
1
PoE and POE+ Port Connections
The 10/100/1000 PoE and PoE+ ports have the same autonegotiation settings and cabling requirements that
are described in the
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
46
100BASE-TX and 1000BASE-T traffic requires twisted four-pair, Category 5 or higher. 10BASE-T
traffic can use Category 3 cable or higher.
10/100/1000 Ports, on page
Crossover Cable
Yes
Yes
No
No
No
4. These ports can provide PoE and PoE+ inline power.
Installing the Switch
Straight-Through Cable
No
No
Yes
Yes
Yes
Hide quick links:
Advertisement
Table of Contents
