Lead-Free Solder - Sony EVI-HD7V Service Manual
Hd color video camera
Hide thumbs
Also See for EVI-HD7V:
- Operating instructions manual (92 pages) ,
- Technical manual (40 pages) ,
- Brochure (8 pages)
Table of Contents
Advertisement
8. Disconnect the fl exible fl at cable from the connector
on the pan motor.
9. Remove the three hooks, then remove the FFC cover
and FFC reel.
10. Remove the four screws, then remove the pan motor.
11. To install, reverse the removal procedure.
n
When replacing the reel sheet, apply grease to the
upper surface of the reel sheet with 50% or more in
width and 0.5 mm or less in width (Floil SG-941
manufactured by Kanto Kasei). If the grease is already
applied, this is not required.
1-8. Lead-free Solder
Boards requiring use of lead-free solder are printed with a lead free mark (LF) indicating the solder
contains no lead.
(Caution: Some printed circuit boards may not come printed with the lead free mark due to their particular
size.)
: LEAD FREE MARK
m
. Be sure to use the lead-free solder for the printed circuit board printed with the lead free mark.
. The lead-free solder melts at a temperature about 40 dC higher than the ordinary solder, therefore, it is
recommended to use the soldering iron having a temperature regulator.
. The ordinary soldering iron can be used but the iron tip has to be applied to the solder joint for a slightly
longer time. The printed pattern (copper foil) may peel away if the heated tip is applied for too long, so
be careful.
1-24
PSW2.6 x 6 (Large)
Rear side of
main unit
Upper surface of
reel sheet
Apply grease.
Flexible
flat cable
Pan motor
Connector
FFC reel
Reel sheet
Hooks
FFC cover
EVI-HD7V
Advertisement
Table of Contents
