Advertisement
Compatible Devices: MP-CL1/MP-CL1A
Attach the Lens Cover Stand to MP-CL1/MP-CL1A.
This allows you to project at various angles and use as lens cover.
When protecting the projector's lens (A)
Attach the lens cover stand by sliding from left to right.
When projecting on a wall or in front (B)
Attach the lens cover stand by sliding from left to right, then rotate the stand and adjust the tilt of the projector to set the projection position. You can choose from two angles.
When projecting on the ceiling (C)
Attach the lens cover stand by sliding it from the bottom to the top, then rotate the stand.
Slide the lens cover stand when you attach or remove it from the mobile projector.
Dimensions: 77.0 mm × 17.1 mm × 19.1 mm (3 1/8 inches × 11/16 inches × 25/32 inches) (W/H/L)
Weight: Approx. 9.0 g (0.3 oz.)
Operating temperature: 0°C to 35°C (32°F to 95°F)
Our product warranty is limited only to the unit itself, when used normally in accordance with the operating instructions and the system environment. Therefore, Customer acknowledges and agrees that:
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download SONY MP-LCS - Lens Cover Stand Instructions And Review
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the MP-LCS that isn't answered in the manual? Leave your question here.