Cisco Firepower 9300 Installation & Maintenance page 9
Installation, maintenance, and upgrade guide
Hide thumbs
Also See for Firepower 9300:
- Hardware installation manual (84 pages) ,
- Command reference manual (421 pages) ,
- Preparative procedures & operational user manual (72 pages)
Table of Contents
Advertisement
Installation, Maintenance, and Upgrade
Note
Verify that you have the correct ROMMON on the Supervisor to support hot swapping. For
instructions on how to verify your firmware package version and to upgrade the firmware if
necessary, see the
To remove and replace the network modules that do not currently support hot swapping, power off the chassis,
replace the network module, and then power the chassis back on.
Note
Verify that you have the correct ROMMON on the Supervisor to support the 100-Gb network modules
(FPR9K-NM-4X100G and FPR9K-NM-2X100G). For instructions on how to verify your firmware
package version and to upgrade the firmware if necessary, see the
Firmware Upgrade
The following figure shows the front panel of the 10-Gb nonhardware bypass network module. The location
of the captive screw, ports, and LEDs is shown. See
single-wide network modules.
Figure 4: Firepower Network Module 10 Gb
1
Captive screw/handle
3
Ethernet X/3
Ethernet X/7
5
7
Ethernet X/4
9
Ethernet X/8
Cisco Firepower 4100/9300 FXOS Firmware Upgrade
Guide.
Install, Remove, and Replace the Single-Wide Network Module
Guide.
Cisco Firepower 4100/9300 FXOS
Network Modules
for more information about the other
2
Ethernet X/1
4
Ethernet X/5
Ethernet X/2
6
8
Ethernet X/6
10
Network activity LEDs
• Off—No connection or port is not in use.
• Amber—No link or network failure.
• Green—Link up.
• Green, flashing—Network activity.
Installation, Maintenance, and Upgrade
9
Advertisement
Table of Contents
