Remove And Replace The Power Supply Module - Cisco Firepower 9300 Installation & Maintenance
Installation, maintenance, and upgrade guide
Hide thumbs
Also See for Firepower 9300:
- Hardware installation manual (84 pages) ,
- Command reference manual (421 pages) ,
- Preparative procedures & operational user manual (72 pages)
Table of Contents
Advertisement
Installation, Maintenance, and Upgrade
Figure 8: Install the 100-Gb Network Module
Step 5
Gently push on the handle until it is fully seated on the network module faceplate and the module is fully seated in the
chassis.
Step 6
Tighten the captive screw on the left of the network module.
Step 7
Power on the chassis so that the new network module is recognized.
Follow the procedures in the
been discovered correctly by the Firepower 9300.
Remove and Replace the Power Supply Module
You can remove and replace the power supply module while the system is running. Make sure that at least
one of the power supply modules is active while hot-swapping.
Note
FXOS Configuration Guide
Replace power supplies immediately. Power supply blanks are not available.
Remove and Replace the Power Supply Module
to connect to the network module and make sure that it has
Installation, Maintenance, and Upgrade
17
Advertisement
Table of Contents
