Page 1
XR-4740RDS/C430RDS/C440RDS SERVICE MANUAL AEP Model UK Model Ver 1.1 2001.06 Photo: XR-C430RDS For RM-X2S (Remote Commander), Model Name Using Similar Mechanism please refer to RM-X2S/X3S Service Tape Transport Mechanism Type MG-25B-136 Manual (9-960-039-∏) previously issued. (XR-C440RDS ONLY) SPECIFICATIONS Cassette player section...
TABLE OF CONTENTS SERVICING NOTES Flexible Circuit Board Repairing GENERAL • Keep the temperature the soldering iron around 270° C during Location of Controls ............3 repairing. Setting the Clock ............... 3 • Do not touch the soldering iron on the same conductor of the Using the rotary remote .............
Page 3
SECTION 1 This section is extracted from instruction manual. GENERAL – 3 –...
SECTION 2 DISASSEMBLY Note: Follow the disassembly procedure in the numerical order given. FRONT PANEL ASS’Y 1 Push the button (release). 2 Remove the front panel ass’y to the direction of the arrow A . COVER ASS’Y 3 cover ass’y –...
Page 10
SUB PANEL, MECHANISM DECK (MG-25B-136) 5 screw (PTT2.6 × 6) 3 connector (CN302) 6 mechanism deck (MG-25B-136) 4 flexible flat cable (CN301) 2 sub panel 1 three screws (PTT2.6 × 8) 1 three screws (PTT2.6 × 8) 4 seven screws MAIN BOARD, HEAT SINK (PTT2.6 ×...
SECTION 3 ASSEMBLY OF MECHANISM DECK Note: Follow the assembly procedure in the numerical order given. HOUSING 7 Hold the hanger by bending the claw. 5 Fit projection on C part. 2 Install the hanger onto 1 Install the catch to the hanger. two claws of the housing.
Page 12
LEVER (LDG-A) / (LDG-B) shaft A shaft A shaft B shaft C shaft C 1 Fit the lever (LDG-A) on 4 type-E stop ring 2.0 shafts A – C and install it. 2 Pull the lever in the arrow direction. 3 Fit the lever (LDG-B) on shafts A and C and install it.
SECTION 4 SECTION 5 MECHANICAL ADJUSTMENTS ELECTRICAL ADJUSTMENTS 1. Clean the following parts with a denatured-alcohol-moistened TEST MODE swab: This set have the test mode function. In the test mode, FM Auto playback head pinch roller Scan/Stop Level and AM (MW) Auto Scan/Stop Level adjustments rubber belt capstan can be performed easier than it in ordinary procedure.
FM Stereo Separation Adjustment TUNER SECTION 0dB=1µV Setting: SOURCE button: FM Cautions during repair When the tuner unit is defective, replace it by a new one because FM RF signal level meter antenna jack (J1) generator its internal block is difficult to repair. 0.01 µ...
Page 16
FM Signal Meter Adjustment MW Auto Scan/Stop Level Adjustment Setting: Make this adjustment after “FM Auto Scan/Stop Level Adjustment”. SOURCE button: FM Setting: SOURCE button: MW FM RF signal generator 30 Ω 15 pF antenna jack (J1) 0.01 µ F 65 pF Carrier frequency : 98.00 MHz MW RF signal...
Page 17
Adjustment Location: Tape Speed – SET UPPER VIEW – Adjustment RV1 MW Auto Scan/Stop level Adjustment RV2 FM Auto Scan/Stop level Adjustment RV3 FM Noise Focus Adjustment RV4 FM Stereo separation Adjustment FM Signal Meter Adjustment – 17 –...
Page 20
IC360 MM1322XFBE 8 OUT2 OUT1 IC601 BA3918-V2 REGULATOR OVER VOLTAGE PROTECT – 2 3 4 IC701 BA8270F-E2 BUS ON BUS ON SWITCH RESET SWITCH BUS ON CLK IN BATTERY BATT BU IN SWITCH VREF DATA DATA IN DATA OUT – 20 –...
Page 25
6-5. IC PIN FUNCTION DESCRIPTION MAIN BOARD IC501 MN1884820S4G (4740RDS) (MASTER CONTROLLER) IC501 MN1886426S4H (C430RDS/C440RDS) (MASTER CONTROLLER) Pin No. Pin Name Function TUNMUT Tuner muting control pin At muting: “H” AMPON Power amp power supply control pin Illumination power supply control pin ILLON At PW SEL on: ACC on: “H”...
Page 26
A/D reference voltage input pin (connected to GND in this set) AVSS – – BUSON BUS ON control signai output pin (for SONY BUS) (C430RDS/C440RDS only) SYSRST System reset signal output pin (for SONY BUS) (C430RDS/C440RDS only) SEKOUT SEEK control signal output pin...
SECTION 7 EXPLODED VIEWS NOTE: • The mechanical parts with no reference • -XX and -X mean standardized parts, so they • Items marked “*” are not stocked since they may have some difference from the original are seldom required for routine service. Some number in the exploded views are not sup- one.
Page 28
(2) FRONT PANEL SECTION not supplied (KEY board) LCD901 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark 3-010-396-01 KNOB (D-BASS) 3-010-387-01 BUTTON (PRESET) 3-010-398-01 BUTTON (RELEASE) (6 . 1. 2. 3. 4. 5. 6. DSPL) 3-010-395-01 SPRING (RELEASE) 3-010-388-01 BUTTON (P.
Page 29
(3) MECHANISM DECK SECTION (MG-25B-136) HP901 M901 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark A-3291-667-A CLUTCH (FR) ASSY 3-008-874-02 CATCHER 3-701-437-21 WASHER 3-933-344-01 GUIDE (C) * 203 3-008-883-01 LEVER (LDG-A) 3-927-100-01 SCREW (+PS 2X10), SPECIAL * 204 3-008-884-01 LEVER (LDG-B) 3-364-151-01 WASHER...
SECTION 8 ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in the • SEMICONDUCTORS When indicating parts by reference In each case, u: µ, for example: number, please include the board. parts list may be different from the parts speci- fied in the diagrams or the components used on uA.
Page 41
XR-4740RDS/C430RDS/C440RDS AEP Model UK Model SERVICE MANUAL Ver 1.1 2001.06 SUPPLEMENT-1 File this supplement with the service manual. Subject: MAIN Board Modification (SPM-01012) In this set, following board has been changed in the midway of production. NEW/FORMER TYPE DISCRIMINATION – MAIN Board (Component Side) –...
Page 42
XR-4740RDS/C430RDS/C440RDS DIAGRAMS 2-1. NOTE FOR PRINTED WIRING BOARD AND SCHEMATIC DIAGRAMS Note on Printed Wiring Board: Note on Schematic Diagram: • All capacitors are in µF unless otherwise noted. pF: µµF • X : parts extracted from the component side.
Page 43
• Semiconductor (C430RDS/C440RDS) Location (C430RDS/C440RDS) CN701 CNJ150 BUS CONTROL IN Ref. No. Location BUS AUDIO LINE OUT (FOR SONY BUS) REAR (ORIGINAL SERVICE MANUAL Page 24) (ORIGINAL SERVICE MANUAL Page 24) POWER BOARD POWER BOARD G-14 CN803 CN802 FM/AM J501...
Page 44
XR-4740RDS/C430RDS/C440RDS 2-3. SCHEMATIC DIAGRAM – MAIN Board (1/3) – (C430RDS/C440RDS) FM/AM TUNER UNIT CNJ150 BUS AUDIO IN LINE OUT REAR C124 R118 R151 C151 C153 25V 3.3k 4.7k 0.47 0.022 R119 C123 C122 C222 C103 R101 C102 C152 100p 100p...
Page 47
XR-4740RDS/C430RDS/C440RDS MAIN 3. ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in the • Items marked “*” are not stocked since they When indicating parts by reference number, please include the board. parts list may be different from the parts speci- are seldom required for routine service.
Page 50
XR-4740RDS/C430RDS/C440RDS MAIN Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark 1-216-065-00 METAL CHIP 4.7K 1/10W R363 1-249-389-11 CARBON 1/4W 1-216-073-00 METAL CHIP 1/10W R364 1-216-073-00 METAL CHIP 1/10W 1-216-097-00 METAL CHIP 100K 1/10W R365 1-216-065-00 METAL CHIP 4.7K...
Page 51
XR-4740RDS/C430RDS/C440RDS MAIN Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark R574 1-216-097-00 METAL CHIP 100K 1/10W (4740RDS) R582 1-216-198-00 METAL CHIP 1/8W R583 1-216-166-00 METAL CHIP 1/8W R584 1-216-238-00 METAL CHIP 1/8W R585 1-216-097-00 METAL CHIP...
Page 52
XR-4740RDS/C430RDS/C440RDS REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page. Ver. Date Description of Revision 2001.06...