Table of Contents
Advertisement
–
+
ELEC
1
2
a
3
1
3
Indication system
4
È
É
B/Y
B/O
2
Fuel level meter display and fuel
indicator
1. Check:
• Fuel level meter display 1 and fuel indi-
cator 2
Do not come on → Replace the dual
analog meter unit.
Checking steps:
1. Remove the fuel pump module assembly.
Refer to "Fuel tank removal" in Chapter 4.
2. Connect the fuel sender coupler 3.
3. Lift the float to the upper position È.
4. Push the unlock button.
5. Check that all fuel level segments come
on.
6. Lower the float to the lowest position É.
7. Check that the fuel indicator 2, the lowest
fuel level segment a, and the "WARN-
ING" indicator light 4 blink.
Check engine warning indicator
1. Check:
• Check engine warning indicator
Does not come on → Check the "Diag-
nosis record" of the YDIS.
Checking steps:
1. Disconnect the engine temperature sensor
coupler 1.
2. Push the unlock button.
3. Check that the "WARNING" indicator light
2 and the check engine warning indicator
3 begin to blink.
4. If the light and indicator do not blink, check
the "Diagnosis record" of the YDIS. If a
diagnosis record is available and it is
caused by the checking steps, replace the
dual analog meter unit.
7-63
E
1
2
3
4
5
6
8
9
Advertisement
Chapters
Table of Contents
