Table of Contents
Advertisement
POWR
Engine unit
c
_
c
d
a
f
h
g
A
b
d
e
e
A
5-22
33. Apply adhesive onto the mating surface of
the connection _, and then install it.
TIP
Align the mark c on the connection with the
mark d on the intake pipe.
34. Install the intake pipe a, and then tighten
the clamps b.
Intake pipe clamp:
3 N·m (0.3 kgf·m, 2.2 ft·lb)
35. Connect the breather hose c to the con-
nection _.
36. Connect the quick connector d to the fuel
rail.
Refer to "Fuel tank removal" in Chapter 4.
37. Connect the electric bilge pump coupler e
and fuel pump module coupler f.
38. Align the plastic tie with the gray tape e
on the wiring harness assembly.
39. Clamp the wiring harness assembly with 5
plastic ties.
40. Connect the remote control receiver cou-
pler g.
41. Install the antenna holders h.
E
1
2
3
4
5
6
7
8
9
Advertisement
Chapters
Table of Contents
