Installing A Rack Or Cabinet; Unpacking And Inspecting A New Switch - Cisco Nexus 7000 Series Hardware Installation And Reference Manual
Hide thumbs
Also See for Nexus 7000 Series:
- Command reference manual (1018 pages) ,
- Reference manual (746 pages) ,
- Configuration manual (536 pages)
Table of Contents
Advertisement
Installing a Rack or Cabinet
• 3/16-inch flat-blade screwdriver
• Crimping tool
• Wire stripping tool
• Tape measure and level
• Grounding wire—Use a wire size that meets local and national installation requirements. Depending on
Note
Installing a Rack or Cabinet
Before you install the Cisco Nexus 7004 chassis, you must install a standard two- or four-post, 19-inch EIA
data center rack (or a cabinet that contains such a rack) that meets the requirements listed in the Cisco Nexus
7000 Series Site Preparation Guide. To maximize safety, you should do the following for the rack:
• Bolt the rack to the concrete subfloor before moving the Cisco Nexus 7004 chassis onto it.
Warning
• If the rack has bonded construction, connect it to the earth ground to enable you to easily ground the
Be sure that the rack includes AC power receptacles with the amperage required for the power supplies that
you will be installing in the chassis. For 3-kW power supplies, you must have 20-A circuits.
Warning
For instructions on setting up the rack, see the documentation that the manufacturer shipped with the rack.
Unpacking and Inspecting a New Switch
Caution
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
26
the power supply and system, a 12 AWG to 6 AWG copper conductor is required for U.S. installations.
We recommend that you use commercially available 6 AWG wire. The length of the grounding wire
depends on the proximity of the switch to proper grounding facilities.
For a list of tools required to assemble and secure the two- or four-post rack or cabinet, see the documentation
that the manufacturer shipped with the rack or cabinet.
Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the floor
before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip over. Statement
1048
system components that you install and to ground your ESD wrist strap. This step minimizes the chance
of electrostatic discharge when you handle ungrounded components while working with them.
Take care when connecting units to the supply circuit so that wiring is not overloaded. Statement 1018
When you handle the Cisco Nexus 7004 chassis or its components, you must follow ESD protocol at all times
to prevent ESD damage. This protocol includes but is not limited to wearing an ESD wrist strap that you
connect to the earth ground.
Installing a Cisco Nexus 7004 Chassis
Advertisement
Chapters
Table of Contents
Troubleshooting
