Table of Contents
Advertisement
PERIODIC MAINTENANCE AND MINOR REPAIR
1
1
2
3
1. Nut
4
3. Remove the defective bulb by pull-
ing it out.
5
1
6
7
8
9
1. Bulb
4. Insert a new bulb into the socket.
5. Install the lens by installing the
nuts.
6. Install the license plate light by in-
stalling the nuts.
CAUTION:
Do not overtighten the nuts, other-
wise the lens may break.
6-31
Supporting the motorcycle
ECA11420
Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
EAU24350
Advertisement
Table of Contents
Troubleshooting
