Installation Warning Statements; Before Attaching The Brackets - Cisco Catalyst 2975 Getting Started Manual

Cisco systems catalyst 2975 switch getting started guide

Hide thumbs Also See for Catalyst 2975:

Table of Contents

Installation Warning Statements

This section includes the basic installation warning statements. Translations of these warning statements appear in the

Regulatory Compliance and Safety Information for the Catalyst 2975 Switch document on the documentation CD.

Warning

To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure

that the system remains stable. The following guidelines are provided to ensure your safety:

This unit should be mounted at the bottom of the rack if it is the only unit in the rack.

When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest

component at the bottom of the rack.

If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the

rack. Statement 1006

Warning

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Statement 1030

To install the switch in a rack, you must first remove the screws from the switch chassis so that the mounting brackets can be

attached. For attachment at the front-mounting position remove one Phillips truss-head screw from the switch side panels. For

attachment at the mid-mounting position, remove two screws. For attachment at the rear-mounting position, remove one screw.

C at al ys t 29

75 G

Se rie s

Po E -4 8

Table of Contents

Show Quick Links

Table of Contents