Completing The Setup Program - Cisco Catalyst 3550 Hardware Installation Manual
Cisco systems multilayer switch user manual
Hide thumbs
Also See for Catalyst 3550:
- Command reference manual (794 pages) ,
- Installation manual (154 pages) ,
- Hardware installation manual (106 pages)
Table of Contents
Advertisement
Appendix D
Configuring the Switch with the CLI-Based Setup Program
Completing the Setup Program
Follow these steps to complete the setup program and to create an initial configuration for the switch:
Enter Yes at these two prompts.
Step 1
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system.
Would you like to enter basic management setup? [yes/no]: yes
Enter a host name for the switch, and press Return.
Step 2
On a command switch, the host name is limited to 28 characters; on a member switch to 31 characters.
Do not use -n, where n is a number, as the last character in a host name for any switch.
Enter host name [Switch]: host_name
Enter an enable secret password, and press Return.
Step 3
The password can be from 1 to 25 alphanumeric characters, can start with a number, is case sensitive,
allows spaces, but ignores leading spaces. The secret password is encrypted and the enable password is
in plain text.
Enter enable secret: secret_password
Enter an enable password, and press Return.
Step 4
Enter enable password: enable_password
Enter a virtual terminal (Telnet) password, and press Return.
Step 5
The password can be from 1 to 25 alphanumeric characters, is case sensitive, allows spaces, but ignores
leading spaces.
Enter virtual terminal password: terminal-password
Step 6
(Optional) Configure SNMP by responding to the prompts. You can also configure SNMP later through
the CLI or Network Assistant. To configure SNMP later, enter no.
Configure SNMP Network Management? [no]: no
Enter the interface name (physical interface or VLAN name) of the interface that connects to the
Step 7
management network, and press Return. For this release, always use vlan1 as that interface.
Enter interface name used to connect to the
management network from the above interface summary: vlan1
Configure the interface by entering the switch IP address and subnet mask and pressing Return. (The
Step 8
IP address and subnet masks shown here are examples.)
Configuring interface vlan1:
Configure IP on this interface? [yes]: yes
IP address for this interface: 10.4.120.106
Subnet mask for this interface [255.0.0.0]: 255.255.255.0
OL-6155-01
Entering the Initial Configuration Information
Catalyst 3550 Multilayer Switch Hardware Installation Guide
D-5
Hide quick links:
Advertisement
Table of Contents
