Installing The Optional Ground Kit - Cisco Catalyst 3550 Hardware Installation Manual
Cisco systems multilayer switch user manual
Hide thumbs
Also See for Catalyst 3550:
- Command reference manual (794 pages) ,
- Installation manual (154 pages) ,
- Hardware installation manual (106 pages)
Table of Contents
Advertisement
Chapter 2
Switch Installation
Installing the Optional Ground Kit
For switches that require a two-hole lug for grounding, you can order a kit containing the ground lug and
hardware from Cisco. For the Catalyst 3550-12G, 3550-24, and 3550-24-FX switches, order part number
NEBS-LUG-3550=.
When you install the ground-lug kit, you cannot connect an RPS to the switch.
Note
To install the ground lug, you need these tools and equipment:
•
•
•
•
Note
The illustrations in this section show the Catalyst 3550-12T switch as an example. Follow the same
procedure to install the ground lug on the Catalyst 3550-24 and 3550-24-FX switches.
To ground the switch to earth ground, follow these steps. Make sure to follow any grounding
requirements at your site.
Use the two Phillips pan-head screws to attach the RPS connector cover to the back of the switch as
Step 1
shown in
If your ground wire is insulated, use a wire stripping tool to strip the 6-gauge ground wire to 0.5
Step 2
inch (12.7 mm) ± 0.02 inch (0.5 mm). (See
Slide the open end of the ground lug over the exposed area of the 6-gauge wire.
Step 3
Using a Panduit crimping tool, crimp the ground lug to the 6-gauge wire. (See
Step 4
Use the two number-10-32 screws to attach the ground lug and wire assembly to the switch rear panel
Step 5
RPS connector cover, as shown in
OL-6155-01
Ratcheting torque screwdriver with a Phillips head that exerts up to 15 pound-force inches (lbf-in.)
or 240 ounce-force inches (ozf-in.) of pressure
Panduit crimping tool with optional controlled-cycle mechanism (model CT-700, CT-720, CT-920,
CT-920CH, CT-930, or CT-940CH)
6-gauge copper ground wire (insulated or noninsulated)
Wire-stripping tool for stripping 6-gauge wires
Figure
2-16.
Figure C-1 on page
Figure
2-18.
Catalyst 3550 Switch Hardware Installation Guide
Installing the Optional Ground Kit
C-2.)
Figure C-2 on page
C-3.)
2-15
Hide quick links:
Advertisement
Table of Contents
