Attaching The Brackets To The Switch; Attaching The Rps Connector Cover - Cisco Catalyst 3550 Hardware Installation Manual
Cisco systems multilayer switch user manual
Hide thumbs
Also See for Catalyst 3550:
- Command reference manual (794 pages) ,
- Installation manual (154 pages) ,
- Hardware installation manual (106 pages)
Table of Contents
Advertisement
Chapter 2
Switch Installation
Attaching the Brackets to the Switch
Figure 2-15
attach the second bracket to the opposite side.
Note
On the Catalyst 3550-24-FX switch, remove the screws that are in the side of the chassis before you
attach the brackets.
Figure 2-15 Attaching the 19-Inch Brackets for Wall Mounting
Attaching the RPS Connector Cover
If you are not using an RPS with your switch, use the two Phillips pan-head screws to attach the RPS
connector cover to the back of the switch, as shown in
Warning
If an RPS is not connected to the switch, install an RPS connector cover on the back of the switch.
Statement 265
Figure 2-16 Attaching the RPS Connector Cover on the Switch
Phillips
pan-head
screws
OL-6155-01
shows how to attach a 19-inch bracket to one side of the switch. Follow the same steps to
100 -24
0V ~
5-3 A
50/ 60H
z
CO NS OL
E
DC OU
TP UT
1
RPS
connector
cover
RPS
connector
Phillips
truss-head
screws
Figure
2-16.
100 -24
0V ~
5-3 A
50/ 60H
z
CO NS OL
E
Catalyst 3550 Switch Hardware Installation Guide
Installing the Switch
2-13
Hide quick links:
Advertisement
Table of Contents
