Site Requirements; Verifying Package Contents - Cisco Catalyst 3550 Hardware Installation Manual
Cisco systems multilayer switch user manual
Hide thumbs
Also See for Catalyst 3550:
- Command reference manual (794 pages) ,
- Installation manual (154 pages) ,
- Hardware installation manual (106 pages)
Table of Contents
Advertisement
Preparing for Installation
Site Requirements
When determining where to place the switch, be sure to observe these requirements:
•
•
•
•
If the switch is installed in a closed or multirack assembly, the temperature around it might be greater
Note
than normal room temperature.
•
•
Verifying Package Contents
Carefully remove the contents from the shipping container, and check each item for damage. If any item
Note
is missing or damaged, contact your Cisco representative or reseller for support. Return all packing
material to the shipping container, and save it.
The switch is shipped with these items:
•
•
•
•
•
•
Catalyst 3550 Switch Hardware Installation Guide
2-4
Operating environment is within the ranges listed in
Clearance to front and rear panels is such that
Front-panel indicators can be easily read.
–
Access to ports is sufficient for unrestricted cabling.
–
Rear-panel power connector is within reach of an AC power receptacle.
–
Airflow around the switch and through the vents is unrestricted.
Temperature around the unit does not exceed 113° F (45° C).
Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent
lighting fixtures. Make sure that the cabling is safely away from other devices that might damage
the cables.
For sites requiring compliance to Telcordia GR-1089-CORE Intra-building Lightning requirements,
all 10/100 and 10/100/1000 ports must be connected with shielded cable grounded at both ends.
This Catalyst 3550 Series Hardware Installation Guide
Where to Find the Catalyst 3550 Documentation flyer
Product registration card
AC power cord (AC-powered switches)
One RJ-45-to-DB-9 adapter cable
Mounting kit containing:
Four rubber feet for mounting the switch on a table
–
–
Two 19-inch rack-mounting brackets
Four Phillips flat-head screws for attaching the brackets to the switch (Catalyst 3550-12T
–
and 3550-12G switches)
–
Six Phillips flat-head screws for attaching the brackets to the switch (Catalyst 3550-24,
3550-24-DC, 3550-24-FX, 3550-24PWR, and 3550-48 switches)
–
Four Phillips machine screws for attaching the brackets to a rack
Chapter 2
Appendix A, "Technical Specifications."
Switch Installation
OL-6155-01
Hide quick links:
Advertisement
Table of Contents
