Verify Port Connectivity - Cisco Catalyst 3030 Getting Started Manual
Cisco systems catalyst blade switch getting started guide
Hide thumbs
Also See for Catalyst 3030:
- Getting started (122 pages) ,
- Command reference manual (746 pages)
Table of Contents
Advertisement
Cisco Catalyst Blade Switch 3030 Getting Started Guide
Installation Warning Statements
Insert an appropriate cable into the SFP module port. Insert the other cable end
Step 2
into the other device (see
Figure
9).
Figure 9
Inserting the Cable into the SFP Module Port
1 6 x
1 5 x
1 2 x
1 4 x
1 1 x
1 3 x
C o n s o le
1 6 x
1 5 x
1 4 x
1 3 x
1 2 x
1 1 x
C O N
For a list of supported modules, see the release notes on Cisco.com. For detailed
instructions on installing, removing, and connecting to SFP modules, see the
documentation that came with the SFP module.
Removing and installing an SFP module can shorten its useful life. Do not remove
Caution
and insert SFP modules more often than is absolutely necessary.
Verify Port Connectivity
After you connect to the switch port, the port LED turns amber while the switch
establishes a link. This process takes about 30 seconds, and then the LED turns
green when the switch and the target device have an established link. If the LED
is off, the target device might not be turned on, there might be a cable problem, or
there might be a problem with the adapter installed in the target device. See the
"In Case of Difficulty" section on page 1-22
for information about online
assistance.
Cisco Catalyst Blade Switch 3030 Getting Started Guide
1-21
78-17052-01
Advertisement
Table of Contents
