Fcc Class A Compliance - Cisco Gigabit Switch Router 12012 Replacement Instructions Manual
Cisco systems gigabit switch router instruction manual
Hide thumbs
Also See for Gigabit Switch Router Cisco 12012:
- Replacement instructions manual (34 pages) ,
- Installation instructions manual (14 pages) ,
- Installation and configuration manual (310 pages)
Table of Contents
Advertisement
Step 3
Step 4
The system is now ready for installation. Open the accessories box and locate the documentation
package that accompanies the Cisco 12012 GSR. Follow the installation procedures in the
Cisco 12012 Gigabit Switch Router Installation and Configuration Guide.
FCC Class A Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which
case users will be required to correct the interference at their own expense.
You can determine whether your equipment is causing interference by turning it off. If the
interference stops, it was probably caused by the Cisco equipment or one of its peripheral devices.
If the equipment causes interference to radio or television reception, try to correct the interference
by using one or more of the following measures:
•
Turn the television or radio antenna until the interference stops.
•
Move the equipment to one side or the other of the television or radio.
•
Move the equipment farther away from the television or radio.
•
Plug the equipment into an outlet that is on a different circuit from the television or radio. (That
is, make certain the equipment and the television or radio are on circuits controlled by different
circuit breakers or fuses.)
Modifications to this product not authorized by Cisco Systems, Inc. could void the FCC approval
and negate your authority to operate the product.
If the large cardboard box contains AC-input power supplies, perform the following steps
to remove them from the packaging:
Remove the two foam inserts covering the AC-input power supplies.
(a)
Grasp the AC-input power supply handle and carefully lift the power supply out of
(b)
the box. Set the power supply aside.
Repeat Step a and Step b for a second AC-input power supply.
(c)
Grasp the edges of the large cardboard box and pull the box out, away from the system,
to release the two foam brackets positioned under the air filter tray. Remove the box from
the pallet and set it aside.
Cisco 12012 Gigabit Switch Router Replacement Instructions
FCC Class A Compliance
5
Advertisement
Table of Contents
