Table of Contents
Advertisement
6.9.2 To replace the charging plates on the product
When the product's battery does not recharge this may
be due to worn or damaged charging plates.
The charging plates are included in the rear sensor
To replace the rear sensor module on
module. Refer to
page 21 .
Also check the contact plates on the charging station.
Refer to
To replace the charging tower on page 28 .
6.10 To clean and replace the ventilation filter
Note: The ventilation filter needs to be cleaned regularly
and must be replaced if damaged.
1. Disassemble the body. Refer to
body system on page 16 .
®
2. Only for Husqvarna
the STOP button, refer to step 3-5 in
disassemble the upper chassis on page 18 .
3. Disassemble the filter cover with a small screwdriver
and carefully push one side of the cover outwards.
4. If the filter is not damaged. Clean the filter carefully
with a clean and soft brush and move to step 8.
5. Remove the damaged filter.
6. Clean thoroughly around the mounting surfaces.
7. Apply the new filter, ensuring the adhesive surfaces
fasten properly to the chassis.
8. Refit the filter cover.
®
9. Only for Husqvarna
STOP button.
10. Reassemble the body system. Refer to
the upper chassis and the body system on page
27 .
6.11 To replace the keypad
1. Disassemble the body system. Refer to
disassemble the body system on page 16 .
2. Disassemble the upper chassis. Refer to
disassemble the upper chassis on page 18 .
3. Peel off the keypad from the chassis.
4. Clean the chassis from glue residue.
1413 - 003 - 17.01.2022
To disassemble the
®
and McCULLOCH
. Remove
To
®
and McCULLOCH
, refit the
To assemble
To
To
5. Remove the protective liner from the new keypad,
and press the keypad into position.
CAUTION: There must not be any loose
corners or air bubbles as this can cause dirt
and moisture to get in under the keypad.
6. Reconnect the new keypad to the HMI circuit board.
7. Reassemble the upper chassis and the body
To assemble the upper chassis and
system. Refer to
the body system on page 27 .
6.12 To replace the body suspension parts
1. Lift up the body suspension parts by using a
small flat screwdriver. Pull the screwdriver gently
backwards.
2. Put the screwdriver between the suspension system
and the lower chassis. Push the screwdriver
upwards and remove the suspension part.
3. To assemble the body suspension parts, refit the
pin into the slot and refit the ring into the correct
position.
Repair instructions - 25
Hide quick links:
Advertisement
Table of Contents
