Cisco CX-TRIP2 Installation And Configuration Manual page 22

Cisco systems token ring interface processor installation and configuration guide

Hide thumbs

Table Of Contents

Table of Contents

Conﬁguring the Interfaces

Step 3

Step 4

Step 5

The conﬁguration process is complete. Proceed to the section "Checking the Conﬁguration" on

page 24. It provides show commands you can use to display and verify the conﬁguration

information.

Using the Conﬁgure EXEC Command

The conﬁgure EXEC command allows you to conﬁgure the interfaces for interface processors in the

Cisco 7000 series and Cisco 7500 series. At the privileged command level, enter the ? command to

display a list of privileged level EXEC commands.

To display information about the interface, including the software and hardware versions and the

controller status, use the show controller cxbus command. To display statistics about the interfaces,

use the show interfaces command.

Identifying Slot and Interface Numbers

Use the show interfaces command to determine which interfaces you need to conﬁgure and to

determine the interface type, slot numbers, and port numbers.

The number of ports you conﬁgure depends on the number of ports available on the interface

processor. For example, if you install a TRIP with four ports in slot 0, conﬁgure the Token Ring

interface for each of these ports as follows: 0/1, 0/2, 03/ and 0/4. The maximum number of ports

available on the TRIP is four.

After identifying the port numbers for the interfaces, conﬁgure the interfaces as described in the

section "Basic Conﬁguration Guidelines" on page 23.

22 Token Ring Interface Processor (TRIP) Installation and Conﬁguration

Proceed through the remainder of the global parameter prompts, using the Return key to

accept the defaults.

After the global parameters are conﬁgured, the system prompts you for interface

conﬁguration information, one interface at a time. Following is a partial display of the script

for a previously conﬁgured interface:

Configuring interface parameters:

Configuring interface Token Ring0:

Is this interface in use [yes]:

Tokenring ring speed (4 or 16) [16]

Configure IP on this interface? [yes]:

IP address for this interface: 131.108.6.67

(remainder of display text omitted)

To accept the default at each prompt and retain the existing conﬁguration information, press

the Return key. When you reach the scripts for conﬁguring new interfaces, enter the new

conﬁguration information at each prompt.

When all interfaces are conﬁgured, the system displays the entire conﬁguration script

followed by a prompt for which there is no default (you must enter yes or no):

Use this configuration [yes/no]:

To use the conﬁguration you created, enter yes. To discard the conﬁguration ﬁle and begin

the conﬁguration process again, enter no.

If you entered yes at the prompt, the following message displays:

Press RETURN to get started!

Table of Contents

This manual is also suitable for:

Cx-trip4

Cisco CX-TRIP2 Installation And Configuration Manual page 22

Related Manuals for Cisco CX-TRIP2

Related Products for Cisco CX-TRIP2

This manual is also suitable for:

Table of Contents