Manual Configuration; Obtaining Your Network Information - Cisco IAD2430 Series Hardware Installation Manual
Integrated access devices
Hide thumbs
Also See for IAD2430 Series:
- Overview manual (13 pages) ,
- Software configuration manual (124 pages) ,
- Quick start manual (34 pages)
Table of Contents
Advertisement
Initial Configuration Procedures
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The user prompt is displayed.
Router>
Verify the initial configuration. See the
Step 13
for verification procedures.
Manual Configuration
To configure the Cisco IAD from a console (locally or remotely), see the
Configuration Guide
continue to the
(100BASE-T) port IP address.
For information about obtaining any referenced documentation, see the
Submitting a Service Request" section on page
This section shows how to prepare the Cisco IAD to perform basic communication functions through its
10/100BASE-T and WAN interfaces.
Perform the following initial configuration procedures, as applicable:
•
•
•
•
•
Obtaining Your Network Information
Gather the following information, as applicable, before you begin the configuration process:
•
•
Setting the Fast Ethernet Port IP Address
To configure the Cisco IAD remotely through a Fast Ethernet connection, connect the 10/100BASE-T
port to a live Ethernet connection by using a standard Ethernet cable with RJ-45 connectors. Then
complete this procedure to set the IP address for the port. After setting the address, you can configure the
Cisco IAD remotely through a Telnet connection.
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
4-6
for the configuration instructions. To configure it remotely through Telnet,
"Setting the Fast Ethernet Port IP Address" section on page 4-6
Obtaining Your Network Information, page 4-6
Setting the Fast Ethernet Port IP Address, page 4-6
Configuring a T1/E1 Port for a WAN Connection, page 4-7
Configuring Digital Voice, page 4-8
Verifying and Saving Your Configuration, page 4-8
For 10/100BASE-T ports: IP address
For T1/E1 ports: clock source, framing, line code, cable length
Chapter 4
"Verifying and Saving Your Configuration" section on page 4-8
xvi.
Powering On Cisco IAD2430 Series IADs
Cisco IAD2430 Series Software
to set a Fast Ethernet
"Obtaining Documentation and
OL-4234-06
- Quick Links:
- Cisco Iad2431-8Fxs Iad
- Cisco Iad2431-16Fxs
Hide quick links:
Advertisement
Table of Contents
