Cisco IAD2430 Series Hardware Installation Manual page 77
Integrated access devices
Hide thumbs
Also See for IAD2430 Series:
- Overview manual (13 pages) ,
- Software configuration manual (124 pages) ,
- Quick start manual (34 pages)
Table of Contents
Advertisement
Chapter 4
Powering On Cisco IAD2430 Series IADs
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: xxxxxx
Enter an enable password that is different from the enable secret password. This password is not
Step 7
encrypted (less secure) and can be seen when viewing the configuration.
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: xxxxxx
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports
Step 8
other than the console port:
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: xxxxxx
Respond to the following prompts as appropriate for your network:
Step 9
Configure SNMP Network Management? [yes]:
Community string [public]:
A summary of the available interfaces is displayed.
Choose one of the available interfaces for connecting the router to the management network:
Step 10
Enter interface name used to connect to the
management network from the above interface summary: fastethernet0/0
Respond to the following prompts as appropriate for your network:
Step 11
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: yes
Configure IP on this interface? [yes]: yes
IP address for this interface: 172.1.2.3
Subnet mask for this interface [255.255.0.0] : 255.255.0.0
Class B network is 172.1.0.0, 26 subnet bits; mask is /16
The configuration is displayed:
The following configuration command script was created:
hostname Router
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
enable password xxxxxx
line vty 0 4
password xxxxxx
snmp-server community public
!
no ip routing
!
interface FastEthernet0/0
no shutdown
speed 100
duplex auto
ip address 172.1.2.3 255.255.0.0
!
Step 12
Respond to the following prompts. Enter 2 to save the initial configuration.
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
OL-4234-06
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
Initial Configuration Procedures
4-5
- Quick Links:
- Cisco Iad2431-8Fxs Iad
- Cisco Iad2431-16Fxs
Hide quick links:
Advertisement
Table of Contents
