Table of Contents
Advertisement
1TB remap [Auto]
Attempt to remap DRAM out of the space just below the 1TB boundary. The ability to
remap depends on DRAM configuration, NPS, and interleaving selection, and may not
always be possible.
Configuration options: [Do not remap] [Attempt to remap] [Auto]
DRAM map inversion [Auto]
Inverting the map will cause the highest memory channels to get assigned the lowest
addresses in the system.
Configuration options: [Disabled] [Enabled] [Auto]
Disable DF to external OP SyncFloodPropagation [Auto]
This item allows you to disable SyncFlood to UMC & downstream slaves.
Configuration options: [Sync flood disabled] [Sync flood enabled] [Auto]
Disable DF sync flood propagation [Auto]
Configuration options: [Sync flood disabled] [Sync flood enabled] [Auto]
Freeze DF module queues on error [Auto]
Configuration options: [Disabled] [Enabled] [Auto]
CC6 memory region encryption [Auto]
This item allows you to control whether or not the CC6 save/restore memory is encrypted.
Configuration options: [Disabled] [Enabled] [Auto]
System probe filter [Auto]
This item allows you to enable or disable the probe filter. This has no effect on parts where
the probe filter is fuse disabled.
Configuration options: [Disabled] [Enabled] [Auto]
Memory Clear [Auto]
When this item is set to [Disabled], BIOS does not implement MemClear after memory
training (only if non-ECC DIMMs are used).
Configuration options: [Disabled] [Enabled] [Auto]
PSP error injection support [False]
Configuration options: [False] [True]
5-36
Chapter 5: BIOS Setup
Advertisement
Table of Contents
