Electronic Controls; Fan Speed - LG LP090HED1 Owner's Manual
Packaged terminal air conditioner/heat pump
Hide thumbs
Also See for LP090HED1:
- Manual de usuario (27 pages) ,
- Service manual (64 pages) ,
- Brochure & specs (9 pages)
Table of Contents
Advertisement
Control Locations
Electronic Controls
The controls will look like one of the following.
FAN SPEED
• Every time you push this button, it cycles through the settings as follows:
{High(F2) ¡ Low(F1) ¡ High(F2) ¡ Low(F1)}
TEMP
MODE
Push this button to cycle through the modes from COOL ¡ FAN
-
¡ HEAT¡ COOL.
- COOL
• Fan runs continually for normal cooling operation.
- ENERGY SAVER
• The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and the unit
will check the room air temperature to determine if cooling is
needed.
- FAN
• Fan operation without heating or cooling.
- HEAT
• Fan runs continually for normal heating operation.
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the Temperature setting will raise 2° F after 30 minutes, and once again
after another 30 minutes.
• Push Timer to cycle through the settings from 1 Hour ¡ 2 Hours ¡ ... ¡ 12 Hours maximum.
14 Room Air Conditioner
E/SAVE
'
F
HEAT
FAN
FAN
HIGH
HIGH
COOL
COOL
LOW
LOW
MODE
FAN
POWER
TIMER
TIMER
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button
ON
ON
TIMER
OFF
OFF
again.
• This button takes priority over any other button.
TEMPERATURE SETTING
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range of
54° F to 86° F by increments of 2° F.
• The setting appears in the display.
- Quick Links:
- Common Problems and Solutions
Hide quick links:
Advertisement
Table of Contents
