Table of Contents
Advertisement
LCD screen message
Solution
Auto Take-up Reel Unit
Press the
stopped.
Then set the Auto switch on the auto take-up reel to the off position, set it
back to the original position, and reattach the media to the auto take-up reel.
Internal Temp. High
Lower the room temperature to the range specified.
Lower room
temperature.
Internal Temp. High
Turn off the product. Lower the room temperature to the range specified. If
the message still appears when the power is turned back on, the room
Turn printer off. Wait for
temperature is still too hot.
printer to cool and then
turn on again.
Media Size Error
Raise the media loading lever and remove the currently loaded media. Be
sure the media is at least 11.8 inches (300 mm) wide.
Load correct size media.
If this message appears even when the media is a supported width, turn off
the Media Size Check setting and try printing again.
Media Sensor Error
Press the
Make sure media has an even surface and does not bleed through easily.
Loaded media or sensor
Set the Platen Gap setting to 2.5.
has a problem. Refer to
manual for details of
Make sure the product is not exposed to direct sunlight.
error.
If the error persists, perform a manual feed adjustment in the Media Setup
Media Sensor Error
menu.
Refer to manual for
details of error.
Adjust manually?
Roll Type Error
Make sure the Roll Type setting is correct for the loaded media. Follow the
on-screen instructions to clear the error.
Release and then reset
the media loading lever,
then match Roll Type
setting to actual media.
Refer to manual and
You have not peformed regular cleaning for one month. If you do not clean
perform regular
the print head, nozzle clogs or print head damage may occur.
cleaning.
pause/cancel button and select Job Cancel to cancel printing.
pause/cancel button and select Job Cancel to cancel printing.
158
Advertisement
Table of Contents
