Table of Contents
Advertisement
DISPLAY
RECEIV BULK
TIME OVER
TS NOT MATCH
21. TROUBLESHOOTING
If you encounter one of the problems listed below, please check the possible
causes and solutions before you assume that your RY8 is faulty.
PROBLEM
No power
No sound
selected is
Distorted sound
Bulk data is being received from a MIDI data storage device or
another RY8.
MIDI bulk data transfer failed to complete within a reasonable
period of time, and therefore the operation was terminated.
Meter of the destination pattern is different from the meter of
the source pattern. Clear the destination pattern memory
location and try again.
POSSIBLE CAUSES AND SOLUTIONS
Check if the batteries are dead.
Check if the AC adaptor is properly plugged into the AC power
outlet, and snugly connected to the RY8's [DC IN] jack.
Check if the [VOLUME] slider is set to a reasonable level. The
[VOLUME] slider affects the level of boththe [OUTPUT] jacks
and the [PHONES] jack.
Check the input and output levels of the external mixer or
monitor system.
Check the levels of the drum pads (see Drum Kit Mode, page
54) and backing tracks (see Balance Mode, page 75), or check
to see if any backing tracks are muted (see Mute Mode, page
74).
Check if the User pattern or User song that you
empty.
Check for any bad connections or faulty cables.
Check the input and output levels of external mixer or amp,
and adjust the balance of each accordingly, in conjunction
with the output level of the RY8.
79
COMMENTS
Hide quick links:
Advertisement
Table of Contents
