Table of Contents
Advertisement
Available languages
Available languages
again, contact Customer Support and tell them the
precise fault code.
If a fault occurs, the appliance will not switch to
▯
standby mode.
Suitability test of cookware
This function can be used to check the speed and quality
of the cooking process depending on the cookware.
The result is a reference value and depends on the
properties of the cookware and the element being used.
With the cookware still cold, fill it with approx. 8 oz.
1.
(200 ml) of water and place it on the center of the
cooking zone with the diameter that most closely
matches the base of the cookware.
Go to the basic settings and select the
2.
Touch the settings range.
3.
zone display.
The function has now been activated.
After 10 seconds, the result for the quality and speed of
the cooking process will appear on the cooking zone
display.
Check the result using the table below:
Result
The cookware is not suitable for the element and
‹
will therefore not heat up.*
The cookware is taking longer to heat up than
‚
expected and the cooking process is not going as
well as it ought to.*
The cookware is heating up correctly and cooking
ƒ
is progressing well.
* If there is a smaller element available, try the cook-
ware again on the smaller element.
To reactivate this function, touch the settings range.
Notes
If the diameter of the used cooking zone is much
▯
smaller than the diameter of the cookware, only the
middle of the cookware can be expected to heat up.
This may result in the cooking results not being as
good as expected or being less than satisfactory.
You can find information on this function in the section
▯
~ "Basic settings"
You can find information on the type, size and
▯
positioning of the cookware in the section
~ "Cooking with Induction"
setting.
™‚ƒ
will flash on the cooking
A
How to Obtain Warranty Service
To obtain warranty service for your Product, you should
contact the nearest Bosch authorized servicer.
Model (E) number and FD number
When you contact our service, please have the Model
(E) number and the FD number for your appliance
available.
You can find the identification plate with these numbers:
in the appliance booklet
▯
on the underside of the appliance
▯
You can also find the (E) number on the glass ceramic of
your cooktop. You can check the Customer Service
Index (CSI) and the FD number in the basic settings.
Please refer to the section on ~ "Basic settings"
Questions? Please contact us. We look forward to
hearing from you.
31
Advertisement
Chapters
Table of Contents
