Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Starting to sew
a
Raise the needle by turning the handwheel
toward you (counterclockwise) so that the mark
on the wheel points up. (With models equipped
with
needle by pressing
a Mark
b
Raise the presser foot lever.
a Presser foot lever
c
Place the fabric under the presser foot, pass
the thread under the presser foot, and then
pull out about 5 cm (2 inches) of thread
toward the rear of the machine.
a 5 cm (2 inches)
(needle position button), raise the
once or twice.)
or
b Needle position button
d
While holding the end of the thread and the
fabric with your left hand, turn the handwheel
toward you (counterclockwise) with your
right hand to lower the needle to the starting
point of the stitching.
e
Lower the presser foot lever.
a Presser foot lever
f
On models equipped with a sewing speed
controller, slide the sewing speed controller
to the left or right to adjust the sewing speed.
Refer to "Sewing speed controller (for models
equipped with the start/stop button)"
(page 15).
a Sewing speed controller
g
Slowly press down on the foot controller.
(With models equipped with
button), if the foot controller is not connected,
press
once.)
The machine starts sewing.
(start/stop
or
aStart/stop button
41
2
Hide quick links:
Advertisement
Table of Contents
