Cisco NCS 1004 Manual page 9

Hide thumbs Also See for NCS 1004:

Install Cisco NCS 1004

Figure 11: Four Post Slider Identification

Slide and adjust the length of the slider arm.

Step 2

Integrate the four post slider with the rack. The procedure for the 23" and 19" rack is discussed here:

• 19" rack - the slider can be directly fitted on to a 19" rack. On the front side, insert only the top most screw of the

slider (48-101524-01) and tighten it to a torque value of 4.65 N-m. On the rear side, insert five screws (48-101524-01)

and tighten them to a torque value of 4.65 N-m.

• 23" rack - the slider is fitted on to a 23" rack using an adapter (refer the following image). The formed surface must

always face the inner side of the rack post. On the front side (towards the chassis), insert only the top most screw

of the slider (48-101524-01) and tighten it to a torque value of 4.65 N-m. On the rear side (towards the chassis),

insert five screws (48-101524-01) and tighten them to a torque value of 4.65 N-m. For the adapter portion which is

towards the rack, all the six screws are fitted on the front and rear side.

Install Four Post Slider into an EIA/ ANSI Rack

Install Cisco NCS 1004

Table of Contents