Cisco NCS 1004 Manual page 14
Hide thumbs
Also See for NCS 1004:
- Command reference manual (110 pages) ,
- Hardware installation manual (70 pages) ,
- Manual (52 pages)
Advertisement
Install Four Post Slider into an ETSI rack
2
Slider fixing screws (48-101524-01)
Install Four Post Slider into an ETSI rack
This procedure has details about installing a four post slider in to an ETSI rack.
Step 1
Identify the four post slider and adjust the length of the slider.
Slide the inner slider arm and adjust the length to mate with the rack surface.
Figure 16: Four Post Slider Identification
1
Slide and adjust the length of the slider arm.
Step 2
Integrate the four post slider with the rack.
The slider is fitted on to an ETSI rack using an adapter (refer the following image). The formed surface must always face
the inner side of the rack post. On the front side, insert only the top most screw of the slider (48-101524-01) and tighten
it to a torque value of 4.65 N-m. On the rear side, insert five screws (48-101524-01) and tighten them to a torque value
of 4.65 N-m.
Install Cisco NCS 1004
14
Install Cisco NCS 1004
Advertisement
