Cisco NCS 1004 Manual page 12
Hide thumbs
Also See for NCS 1004:
- Command reference manual (110 pages) ,
- Hardware installation manual (70 pages) ,
- Manual (52 pages)
Advertisement
Install Two Post Slider into an ETSI Rack
Step 1
Identify the two post slider and adjust the length of the slider (3" to 5").
Slide the inner sliders and adjust the length to mate with the rack surface.
Figure 14: Two Post Slider Identification
1
Check for marking on the sliders; slide the inner sliders to adjust the length.
Step 2
Integrate the two post slider with the rack.
The slider is fitted on to an ETSI rack using an adapter (refer the following image). The formed surface must always face
the inner side of the rack post. On the front side, insert only the top most screw of the slider (48-101524-01) and tighten
it to a torque value of 4.65 N-m. On the rear side, insert three screws (48-101524-01) and tighten them to a torque value
of 4.65 N-m.
Install Cisco NCS 1004
12
Install Cisco NCS 1004
Advertisement
