Trim Meter (Digital Type); Hour Meter; Hour Meter (Digital Type) - Yamaha F80A Owner's Manual
Hide thumbs
Also See for F80A:
- Owner's manual (195 pages) ,
- Service manual (80 pages) ,
- Owner's manual (115 pages)
Table of Contents
Advertisement
Basic components
knots, according to operator preference. Se-
lect the desired unit of measurement by set-
ting the selector switch on the back of the
gauge. See the illustration for settings.
1. Cap
2. Selector switch (for speed unit)
3. Selector switch (for fuel sensor)
EMU26620
Trim meter (digital type)
This meter shows the trim angle of your out-
board motor.
NOTE:
Memorize the trim angles that work best
G
for your boat under different conditions.
Adjust the trim angle to the desired using
the power trim and tilt switch.
If the trim angle of your motor exceeds the
G
trim operating range, the top segment on
the trim meter display will blink.
19
EMU26640
Hour meter
The digital hour meter is mounted on the en-
gine inside the top cowling. It measures the
total number of hours the engine has been
run since manufacture. When the main
switch is turned on, initially all segments of
the display will light. The indicator will then
display the number of hours normally.
NOTE:
The number of hours is only measured when
the engine is running. When the main switch
is turned on but the engine is not running, the
digital hour meter will display the hours run
but will not add any additional time to the to-
tal.
EMU26650
Hour meter (digital type)
This meter shows the number of hours the
engine has been run. It can be set to show
the total number of hours or the number of
hours for the current trip. The display can
also be turned on and off.
ZMU01740
ZMU03183
- Quick Links:
- Engine Oil
Hide quick links:
Advertisement
Table of Contents
