Power Trim And Tilt Switch On Bottom Engine Cowling; Trim Tab With Anode - Yamaha F80A Owner's Manual
Hide thumbs
Also See for F80A:
- Owner's manual (195 pages) ,
- Service manual (80 pages) ,
- Owner's manual (200 pages)
Table of Contents
Advertisement
Basic components
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, then tilts it up. Pressing
the switch "
" (down) tilts the outboard mo-
tor down and trims it down. When the switch
is released, the outboard motor will stop in its
current position.
NOTE:
For instructions on using the power trim and
tilt switch, see pages 33 and 35.
EMU26151
Power trim and tilt switch on bottom
engine cowling
The power trim and tilt switch is located on
the side of the bottom engine cowling. Press-
ing the switch "
motor up, then tilts it up. Pressing the switch
"
" (down) tilts the outboard motor down
and trims it down. When the switch is re-
leased, the outboard motor will stop in its
15
" (up) trims the
" (up) trims the outboard
current position.
EWM01030
WARNING
Use the power trim and tilt switch located
on the bottom engine cowling only when
the boat is at a complete stop with the en-
gine off. Attempting to use this switch
while the boat is moving could increase
the risk of falling overboard and could
distract the operator, increasing the risk
of collision with another boat or an obsta-
cle.
UP
DN
1. Power trim and tilt switch
NOTE:
For instructions on using the power trim and
tilt switch, see page 35.
EMU26241
Trim tab with anode
The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
EWM00840
WARNING
An improperly adjusted trim tab could
cause difficult steering. Always test run
after the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
1
ZMU04223
- Quick Links:
- Engine Oil
Hide quick links:
Advertisement
Table of Contents
