Getting Started; Operation - Honeywell HPA060 Series Owner's Manual
Hepa allergen remover air purifiers
Hide thumbs
Also See for HPA060 Series:
- User manual ,
- Owner's manual (12 pages) ,
- Important safety instructions manual (15 pages)
Table of Contents
Advertisement
Available languages
Available languages
GETTING STARTED
• Select a firm, level, and flat location.
• When operating, large volumes of air are drawn toward the air purifier. Surrounding areas should be cleaned
and/or vacuumed frequently to prevent build-up of dust and other contaminants. This may also help prolong
the life of the filter. If the unit is placed on a light colored carpet, a small mat or rug should be used underneath
to prevent staining. This is especially important in homes with contamination from smoking, fireplaces, or
where candles are burned.
• Ensure the front of the unit faces away from the closest wall or furniture.
• Ensure no grilles are blocked.
INSTALL CERTIFIED HEPA FILTERS AND ODOUR REDUCING PRE-FILTER
The Certified HEPA Filters are supplied within the air purifier. They are wrapped to ensure
purity, and are labeled to help identify the proper replacement filter
• Before using your new air purifier you must remove the wrapper covering the filter(s).
Make sure the air purifier is OFF and unplugged. While pressing on the tab at the top
of the rear grille, pull the grille towards you and remove it from the unit and set it aside
(See Fig. 2). Grasp the sides of each filter frame near its top end and pull outward.
Repeat for the second filter if applicable.
• Remove protective wrap from the filter(s).
• Place the HEPA Filter(s) into the air purifier housing with the arrows pointing toward
the unit. Insert the bottom edge of the filter frame and press the top of the filter down
and inward until the filter is firmly in place. Repeat for the second filter if applicable.
Install the Household Gas & Odour Reducing Pre-Filter that is supplied within the air purifier.
It will be wrapped in plastic wrap to keep it fresh
• Remove the pre-filter from the protective plastic bag.
• Secure the pre-filter under the pre-filter clips on the inside of the rear grille.
• Replace the rear grille by lining up the tab at the bottom of the grille with the slot in the air purifier.
Push the top of the grille towards the unit until it snaps in place. Snap the filter grille back into place.
OPERATION
The energy efficiency of this ENERGY STAR certified model is measured based on a ratio between the model's
CADR for Smoke and the electrical energy it consumes, or CADR/Watt.
H
.
Filter
.
+
B
Pre-Filter
4
Fig. 2
Hide quick links:
Advertisement
Table of Contents
