Table of Contents
Advertisement
EAS31250
REMOVING THE FUEL HOSE
1. Disconnect:
• Fuel hose
EWA17610
WARNING
Cover fuel hose connections with a cloth
when disconnecting them. Residual pres-
sure in the fuel lines could cause fuel to
spurt out when removing the hoses.
ECA20020
NOTICE
Although the fuel has been removed from
the fuel tank, be careful when removing the
fuel hose, since there may be fuel remaining
in it.
TIP
• To remove the fuel hose from the fuel injector,
slide the fuel hose connector cover "1"on the
end of the hose in the direction of the arrow
shown, and then remove the hose.
• Before removing the hose, place a few rags in
the area under where it will be removed.
EAS31251
CHECKING THE FUEL INJECTOR
1. Check:
• Injector
Obstruction → Replace and check the fuel
pump/fuel supply system.
Deposit → Replace.
Damage → Replace.
2. Check:
• Injector resistance
Refer to "CHECKING THE FUEL INJEC-
TOR" on page 7-6.
EAS31617
INSTALLING THE FUEL INJECTOR
1. Install:
• Fuel injector adaptor "1"
New
• O-ring "2"
(to the fuel injector)
• Fuel injector "3"
1
7-6
Fuel injector bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
• Lubricate the O-ring with engine oil.
• Align the projection "a" on the fuel injector
adapter with the hole "b" in the intake manifold.
• Align the projection "c" on the fuel injector with
the hole "d" in the fuel injector adapter.
3
2
New
a
b
EAS31253
INSTALLING THE FUEL HOSE
1. Install:
• Fuel hose
ECA17500
NOTICE
When installing the fuel hose, make sure that
it is securely connected, and that the fuel
hose connector cover on the fuel hose is in
the correct position, otherwise the fuel hose
will not be properly installed.
TIP
• Install the fuel hose securely onto the fuel in-
jector until a distinct "click" is heard.
• To install the fuel hose onto the fuel injector,
slide the fuel hose connector cover "1" on the
end of the hose in the direction of the arrow
shown.
FUEL INJECTOR
c
1
d
1
Advertisement
Chapters
Table of Contents
Troubleshooting
