Cisco Firepower 2100 Getting Started Manual page 203
Hide thumbs
Also See for Firepower 2100:
- Getting started manual (232 pages) ,
- Manual (44 pages) ,
- Getting started manual (150 pages)
Table of Contents
Advertisement
ASA Deployment with ASDM
Example:
firepower-2110 /system/services # delete ip-block 192.168.45.0 24 https
firepower-2110 /system/services* # delete ip-block 192.168.45.0 24 ssh
firepower-2110 /system/services* #
Step 6
(Optional) Reenable the IPv4 DHCP server.
scope system
scope services
enable dhcp-server start_ip_address end_ip_address
You can also enable and disable the DHCP server in the Firepower Chassis Manager at Platform Settings >
DHCP.
Example:
firepower-2110# scope system
firepower-2110 /system # scope services
firepower-2110 /system/services # enable dhcp-server 192.168.4.10 192.168.4.20
Step 7
Save the configuration.
commit-buffer
Example:
firepower-2110 /system/services* # commit-buffer
Step 8
Change the ASA address to be on the correct network. The default ASA Management 1/1 interface IP address
is 192.168.45.1.
a) From the console, connect to the ASA CLI and access global configuration mode.
connect asa
enable
configure terminal
In ASA version 9.12(1) and later, you are prompted to set an enable password. In previous versions, the
default enable password is blank.
Example:
firepower-2110# connect asa
Attaching to Diagnostic CLI ... Press 'Ctrl+a then d' to detach.
Type help or '?' for a list of available commands.
ciscoasa> enable
Password:
The enable password is not set. Please set it now.
Enter Password: ******
Repeat Password: ******
ciscoasa# configure terminal
ciscoasa(config)#
b) Change the Management 1/1 IP address.
(Optional) Change the FXOS and ASA Management IP Addresses or Gateway
Cisco Firepower 2100 Getting Started Guide
201
Advertisement
Chapters
Table of Contents
