Connect To Your Network - D-Link DIR-451 Quick Install Manual

Hide thumbs Also See for DIR-451:

Table of Contents

Available languages

Connect to your network

Note: Ensure that power to your DIR-451 Mobile Router is not connected before

performing the installation steps below.

32-bit PCMCIA (UMTS) Card Connection

1. Attach the antenna.

a. Remove the antenna from its plastic wrapper.

b. Screw the antenna in a clockwise direction to the back panel of the

unit.

c. Once secured, position the antenna upward at its connecting joint. This

will ensure optimal reception.

2. Insert your wireless 32-bit PCMCIA (UMTS) Card into the Internet Card

Slot on the back of the router.

3. Insert the Ethernet cable into LAN Port 1 on the back panel of the DIR-451

Mobile Router, and an available Ethernet port on the network adapter in

the computer you will use to configure this unit.

Note: The DIR-451 Mobile Router LAN Ports are "Auto-MDI/MDIX." This provides

either patch or crossover Ethernet cable LAN Port access.

4. Connect the power adapter to the receptor on the back panel of your

DIR-451 Mobile Router. Then plug the other end of the power adapter into

a wall outlet or power strip.

a. The Power LED will turn ON to indicate power has been applied.

b. Other LEDs will flash ON and OFF as the DIR-451 Mobile Router

performs initialization and Internet connection processes. This will

take a few minutes.

c. When complete, the following LEDs will illuminate blue: Power,

Status, Internet, WLAN, and LAN Port 1 (or your specific LAN Port

connection).

Table of Contents