Table of Contents
Advertisement
Final transmission oil
The nal transmission case must be
checked for oil leakage before each
ride. If any leakage is found, have a
Yamaha dealer check and repair your
motorcycle. In addition, the nal trans-
mission oil must be changed as follows
at the intervals speci ed in the periodic
maintenance and lubrication chart.
1. Start the engine and warm up the
nal transmission oil by riding the
motorcycle for several minutes.
2. Stop the engine and then place
the motorcycle on the center-
stand.
3. Place an oil pan under the nal
transmission case to collect the
used oil.
4. Remove the nal transmission oil
ller cap and its O-ring from the -
nal transmission case.
Periodic maintenance and adjustment
EAU67822
1. Final transmission oil ller cap
2. O-ring
5. Remove the nal transmission oil
drain bolt and its gasket to drain
the oil from the nal transmission
case.
1. Final transmission oil drain bolt
2. Gasket
10-12
6. Install the
1
drain bolt and its new gasket, and
then tighten the bolt to the speci-
ed torque.
2
TIP
Before installing the nal transmis-
sion oil drain bolt and gasket, ap-
ply oil to them.
Wipe off any excess oil after-
wards.
Tightening torque:
Final transmission oil drain bolt:
20 N·m (2.0 kgf·m, 15 lb·ft)
7. Re ll with the speci ed amount of
the recommended nal transmis-
sion oil. WARNING! Make sure
that no foreign material enters
the
Make sure that no oil gets on
the tire or wheel.
2
1
Recommended nal transmission
oil:
See page 12-1.
Oil quantity:
0.10 L (0.11 US qt, 0.09 Imp.qt)
nal transmission oil
nal transmission case.
[EWA11312]
10
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
