Table of Contents
Advertisement
Installation
5.4 Softkey labeling
See also
Preparation for mounting (Page 97)
5.4
Softkey labeling
User-specific functions can be assigned to the vertical softkey bars. Printed labeling strips can
be used to label the vertical softkeys.
Blank labels are already installed on delivery.
DIN A4 films are available for making the strips (for the article number, see Chapter Spare
parts (Page 105)).
Note
Use the "Arial" font to format text. This font is comparable to the "Univers S57" font, used by
Siemens for the key labeling.
Procedure
1. Letter the mat side of the film using a laser printer.
2. Cut the printed labels along the preprinted lines.
3. Remove the PCU retaining screws and swing out the PCU away from the operator panel
front.
4. Insert the strips into the slots provided on the rear of the operator panel front.
5. Swing the PCU back to the operator panel and secure by tightening the screws.
If the operator panel front and PCU are dismantled, omit steps 3 and 5.
102
Operator panel front: OP 010
Manual, 07/2018, A5E36371538B
Advertisement
Table of Contents
